I made a torture board from a length of 6mm ply, some scrap pine, and a 120 grit sanding belt to start going over the hull and fairing things up. I did take the hulls outside and bolted them together for sanding, but got rained on before I thought to take a picture of it all together...next time.
After sanding as much I could inside I decided to cut out the cockpit floors. One floor must be two pieces since I'm using remnants of 6mm sheet used for hull bottoms and it's not possible to get them both as one piece. I knew this would be the case, and it doesn't hurt anything..just have to do a butt joint there.
No comments:
Post a Comment